Hull

• One-Piece Bottom Construction
• Non-Trip of Latest Design
• Lengths Available 12’ & 14'
• Beam 7 ½' or 8'
• Height of Midship 22 Inches
• Transom Min. 17 Inches
• Transom Relieved 15 Degrees for Rear Wash Safety
• All Welded Aluminum Construction Bottom and Transom Marine Alloy 5086 .190
• Bulkhead & Sides Marine Alloy 5052 .125
• Bottom Stiffeners Equally Spaced Across Bottom
• Min. 5 - 2” X 2” X ¼” T-Bar Stringers (7 T-bars on 8' models)
• Full Deck Over with 2 Access Doors (Port & Starboard)
• Storage Under Bow with Flush Mount Lockable Access with Drip Rail
• Top of Deck will be Non-Skid (Your Choice of Color)
• Custom Hull Stripe

Polymer

• ¼” Polymer Bottom Attached with Stainless Steel Fasteners

Engine

• New 350 C.I.D. / 350 HP General Motors Engine
• 12 Volt 65 Amp Alternator with Dual Belt/ Pulley System
• Electric Gear Reduction Starter
• Electric Fuel Pump with Fuel Filter/Water Separator
• U.S.C.G. Approved Fuel Lines
• Certified Marine Spark Arrestor/ With Rain Cover
• HEI Distributor
• Heavy-Duty Flywheel

Optional Engine

• Lycoming Aircraft 6 Cyl. 540 C.I.D. / 260 or 300 HP

Reduction

• Stinger Gear Reduction 2.09 to 1 Ratio

Propeller

• Adjustable Pitch Composite Propeller Matched to the Horse Power of Engine

Seating

• Seating for Three/Single Rear Operator, Double Seat Up Front
• Your Choice of Color Custom Marine Vinyl Seat Cushions & Rain Covers

Rigging

• Steel Super Structure with 1 ¼” Engine Stand Supports (Powder Coated - Your Choice of Color)
• Steel Seat Package & Cage (Powder Coated - Your Choice of Color)

Equipment

• Cable Steering Attached to Top of Rudders
• Stainless Steel Flex Pipe 3”
• Stainless Steel Headers
• Stainless Steel Mufflers
• Heavy-Duty Engine Cooling Aluminum Radiator
• Aluminum Coolant Expansion Tank
• U.S.C.G. Approved Radiator Hoses
• Custom Instrument Panel
• Complete Bilge System
• Dual Batteries with Battery Boxes
• Ignition-Protected Battery Selector Switch
• Certified 30-Gallon Aluminum Fuel Tank with Remote Fill
• 4-Foot Air Foiled Aluminum Rudders, Foam Filled, Nylon Bushings
• Stainless Steel Rudder Rods
• Rudders Attached with Rod Ends
• All Stainless Steel Fasteners
• KC Lights Attached to Cage
• Floor Board Courtesy Light

Instrumention

• Marine Standard Wiring
• Lighted Marine Gauges
• Labeled Marine Toggle Switches
• Voltmeter
• Temperature Gauge
• Oil Pressure Gauge
• Tachometer
• Hour Meter
• Fuel Gauge
• Marine Keyed Ignition
• 1 - 12 Volt Marine Power Point
• Fuse Panel with Circuit Breakers
• U.S.C.G. Approved Navigational Lights
• Engine Warning System

Trailer

• Galvanized
• Single Axle (3500 lbs.)
• 2” Heavy-Duty Coupler
• Heavy-Duty Tongue Jack with Wheel
• Heavy-Duty Wench
• Easy Grease Bearings
• Carpet Side Boards
• D.O.T. Lights